The BC-1(R) provides an internal terminal assembly for wiring the batteries to the fire alarm control panel power supply terminals. Install the battery cabinet in accordance with CAN/ULC-S524 Installation of Fire Alarm Systems. Install the battery cabinet in the same room as the fire alarm control panel.
Reinstall the left side panel on the left-most battery cabinet after interconnection. Push the third battery cabinet into position, align with the seismic anchoring (if any), level the battery cabinet, and interconnect with the other battery cabinets as described in step 2, step 3, and step 5.
Remove the side panels that are adjacent to the other battery cabinets. Push the right-most battery cabinet into position. For seismic anchoring, ensure that the rear seismic bracket connects to the rear anchors. Lower the levelling feet until they connect with the floor - use a bubble-leveler to ensure that the cabinet is level.
Refer to Figure 4 for BC-1(R) cabinet dimensions. Attach the wall box to the wall using the mounting holes on the back of the wall box. See Figure 1. Use fasteners that can support the full weight of the cabinet, including the batteries.
Connect the power system''s battery cable terminated in an Anderson connector to the first battery cabinet''s battery cable terminated in a mating Anderson connector.
Free Quote
NOTE: This procedure describes how to position and interconnect several battery cabinets. If your system only has one battery cabinet, you only need to follow step 2 and step 3.
Free Quote
The Eaton® Samsung Gen 3 Battery Cabinet provides power for energy storage and emergency backup power for the Eaton Uninterruptible Power Supply (UPS) systems to enhance the usability and
Free Quote
The documentation available online is generally the latest version.
Free Quote
REMOTE BATTERY CABINET SYSTEM: ALL CABLE HARNESSES FROM BATTERY CABINET TO BATTERY CABINET AND BATTERY CABINET TO UPS WILL BE PROVIDED BY THE
Free Quote
4001-9809 External Battery Box Installation Instructions CAUTION: Ensure power to control panel is OFF before proceeding. Mount the external battery box as follows:
Free Quote
This manual contains important instructions that should be followed during installation of VertivTM Liebert® APM2 Battery Cabinet and accessories. Read this manual thoroughly, paying special
Free Quote
Battery cabinets that are not supplied with an incorporated DC output disconnect device must have an appropriate disconnect device provided external to the cabinet.
Free Quote
Install the battery cabinet in accordance with CAN/ULC-S524 Installation of Fire Alarm Systems. Install the battery cabinet in the same room as the fire alarm control panel. We recommend the space
Free Quote
In this chapter, instructions here are only for horizontal installation such as: installation in a 19-inch cabinet. Vertical installation is similar. All equipment must be placed steadily after installation.
Free QuotePDF version includes complete article with source references. Suitable for printing and offline reading.
